paloaltonetworks:configuration:lacp
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| paloaltonetworks:configuration:lacp [2020/05/27 16:08] – created bstafford | paloaltonetworks:configuration:lacp [2022/11/23 12:49] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| - | Switch is active. Palo Alto Networks firewall is passive. Transmission rate should be set to slow. | + | Switch is active. Palo Alto Networks firewall is passive. Transmission rate should be set to slow on both the firewall and the switch(s). |
| If on interface from the aggregate group is connected to one switch and other to 2nd switch and both the physical switches are virtually clustered into one, the switch will generate one system ID which would be virtual and will use it for LACP negotiation. The switch will not use a physical system ID since it will be two in numbers and each would be specific to each switch. | If on interface from the aggregate group is connected to one switch and other to 2nd switch and both the physical switches are virtually clustered into one, the switch will generate one system ID which would be virtual and will use it for LACP negotiation. The switch will not use a physical system ID since it will be two in numbers and each would be specific to each switch. | ||
paloaltonetworks/configuration/lacp.1590595738.txt.gz · Last modified: (external edit)